HP CX 6300 Installation And Getting Started Manual page 36

The four-post rack mount for the switches requires the optional J9583A HPE X410 Universal Rack Mounting Kit. To
use this kit to mount a switch, see the installation instructions provided with the kit.
Connect the switch to a power source
For AC power supplies: Plug the included power cord into the power connector on the switch and into a nearby AC
power source.
For DC power supplies: Use the supplied DC power cable with the DC power supply. Follow the instructions in
a power supply or a second power supply for modular switches
supply and DC power source.
When powered by a DC power supply, the product relies upon the installation to provide short-circuit
(overcurrent) protection. Ensure that the protective device is not greater than 20A for non-PoE switches and
not greater than 40A for PoE switches when using DC power.
Make sure the power source is properly grounded before connecting power to the power supply.
Warning: A readily accessible two-pole disconnect device must be provided in the fixed installation.
Recheck the LEDs during self-test.
Install transceivers (optional)
You can install or remove transceivers from the slots on the front of the switch without having to power off the
switch.
The transceivers operate only at full duplex. Half duplex operation is not supported.
n
Ensure that the network cable is NOT connected when you install or remove a transceiver.
n
24 SFP+ switches can support up to 48 transceivers.
n
(Optional) Insert up to four SFP transceivers in the fixed transceiver slots on the switch front panel.
Connect network cables
to connect and install the DC cable to the power
Install
Installing the switch | 36