Using Re-Name - Yamaha RX-V2600 Owner's Manual

Using RE-NAME

You can change the name of the input source that appears
in the display window on the remote control if you want to
use a different name than the factory preset. This is useful
when you have set the input selector to control a different
component.
1
Set AMP/SOURCE/TV to AMP or SOURCE.
AMP
SOURCE
TV
2
Press an input selector button to select the
source component you want to rename.
The selected component name appears in the display
window.
XM
A AUDIO SEL SLEEP
PHONO TUNER CD MULTI CH IN
V-AUX
CBL/SAT MD/TAPE CD-R
DTV VCR 1 DVR/VCR2 DVD
(U.S.A. model)
3
Press RE-NAME using a ballpoint pen or
similar object.
RE-NAME
Note
If you do not complete each of the following steps within 30
seconds, the renaming mode will be automatically canceled.
In this case, press RE-NAME again.
4
Press k / n to select and enter a character.
Pressing n changes the character as follows:
A to Z, 1 to 9, 0, + (plus), – (hyphen), ; (semicolon),
/ (slash), and space.
(Pressing k changes the characters in reverse order.)
PRESET/CH
ENTER
A-E/CAT.
5
Press l / h to move the cursor to the next
position.
PRESET/CH
ENTER
6
Press ENTER to set the new name.
OK appears in the display window if renaming was
successful.
NG appears in the display window if renaming was
unsuccessful. In this case, start over from step 4.
y
If you continuously want to rename another component,
press the input selector button or SELECT k / n to select
the component and then repeat steps 4 through 6.
7
Press RE-NAME again to exit the renaming
mode.
RE-NAME
Note
ERROR appears in the display window if you press a button not
indicated in the respective step, or when you press more than one
button simultaneously.
REMOTE CONTROL FEATURES
A-E/CAT.
109