Yamaha RX-V2600 Owner's Manual page 110

REMOTE CONTROL FEATURES
Setting remote control AMP codes
Select one of the following codes to set the remote control
AMP code for the component you want to use.
Set AMP/SOURCE/TV to AMP or SOURCE and then
change the remote control code settings.
AMP library
code
(remote
control
setting)
To operate this unit using
2001 the default code.
(initial setting) To operate Zone 2 or Zone 3
features (see page 115).
To operate this unit using an
alternative code.
2002
To operate Zone 2 or Zone 3
features (see page 115).
Notes
• You need to set the corresponding remote control AMP ID
(see page 102).
• When using multiple YAMAHA receivers/amplifiers, you
may be able to operate the other components
simultaneously with the default code setting. In this case,
set one of the alternative codes to operate this unit
separately.
Setting remote control tuner codes
Select one of the following codes to set the remote control
tuner code for the component you want to use.
Set AMP/SOURCE/TV to SOURCE and press TUNER
on the remote control to select TUNER as the input source
and then change the remote control code settings.
Tuner
library code
(remote
control
setting)
2602 To operate this unit using
(initial setting) the default code.
To operate this unit using an
2603
alternative code.
Notes
• You need to set the corresponding remote control tuner ID
(see page 102).
• When using multiple YAMAHA receivers/amplifiers, you
may be able to operate the other components
simultaneously with the default code setting. In this case,
set one of the alternative codes to operate this unit
separately.
106
Remote
control
Function
AMP ID
unit's setting:
see page 102)
ID1
(initial setting)
ID2
Remote
control
tuner ID
Function
(this unit's
setting:
see page 102)
ID1
(initial setting)
ID2
Setting remote control XM codes
Select one of the following codes to set the remote control
XM code for the component you want to use.
Set AMP/SOURCE/TV to SOURCE and press XM on the
remote control to select XM as the input source and then
change the remote control code settings.
XM library
(this
code
(remote
control
setting)
2604
(initial setting)
2605
Notes
• You need to set the corresponding remote control XM ID
(see page 102).
• When using multiple YAMAHA receivers/amplifiers, you
may be able to operate the other components
simultaneously with the default code setting. In this case,
set one of the alternative codes to operate this unit
separately.
5
Press ENTER.
The four-digit code set for the selected component
appears in the display window.
Note
0000 appears in the display window if no code has been set.
6
Press the numeric buttons to enter the
four-digit remote control code for the
component you want to use.
For a complete list of available remote control codes,
refer to "LIST OF REMOTE CONTROL CODES" at
the end of this manual.
7
Press ENTER to set the number.
OK appears in the display window if setting was
successful.
NG appears in the display window if the setting was
unsuccessful. In this case, start over from step 3.
y
If you continuously want to set up another code for another
component, press the input selector button or
SELECT k / n to select the component and then repeat
steps 4 through 6.
Function
To operate this unit using
the default code.
To operate this unit using an
alternative code.
STEREO MUSIC ENTERTAIN MOVIE
1 2 3 4
THX STANDARD SELECT EXTD SUR.
5 6 7 8
1 MEMORY 2 A SPEAKERS B
9 0 +10
ENT.
Remote
control XM
ID
(this unit's
setting:
see page 102)
ID1
(initial setting)
ID2