Yamaha RX-V2600 Owner's Manual page 130

Yamaha rx-v2600: owners manual
Hide thumbs Also See for RX-V2600:
Table of Contents

Advertisement

TROUBLESHOOTING
■ AUTO SETUP
Before AUTO SETUP
Error message
Connect MIC!
Unplug Phones!
No Setup Menu!
Memory Guard!
During AUTO SETUP
Error message
E01:No Front SP
E02:No Surr. SP
E03:No PRNS SP
E04:SBR–>SBL
E05:Noisy
E06:Check Surr.
E07:No MIC
E08:No Signal
E09:User Cancel
E10:Internal Err
126
Cause
Optimizer microphone is not connected.
Headphones are connected.
No setup menu items have been selected.
This setting is protected.
Cause
Front L/R channel signal(s) is (are) not
detected.
A surround channel signal is not detected.
A presence channel signal is not detected.
Only right surround back channel signal is
detected.
Background noise is too loud.
Surround back speaker(s) is (are)
connected, though surround L/R speakers
are not.
The optimizer microphone was unplugged
during the AUTO SETUP procedure.
The optimizer microphone does not detect
test tones.
The AUTO SETUP procedure was
cancelled due to user activity.
An internal error occurred.
Remedy
Connect the supplied optimizer microphone to the
OPTIMIZER MIC jack on the front panel.
Unplug the headphones.
Select at least one setup menu item.
Remove the protection setting for AUTO SETUP.
Remedy
Select the front speakers by pressing SPEAKER A or
B on the front panel (or by setting AMP/SOURCE/
TV to AMP and then pressing SPEAKER A or B on
the remote control).
Check the front L/R speaker connections.
Check the surround speaker connections.
Check the presence speaker connections.
Connect the surround back speaker to the LEFT
SURROUND BACK SPEAKERS terminal if you
only have one surround back speaker.
Try running AUTO SETUP in a quiet environment.
Turn off noisy electric equipment like air conditioners
or move them away from the optimizer microphone.
Connect surround speakers when you use (a)
surround back speaker(s).
Connect the supplied optimizer microphone to
OPTIMIZER MIC jack on the front panel.
Check the microphone setting.
Check the speaker connections and placement.
Run AUTO SETUP again.
Run AUTO SETUP again.
See
page
32
98
See
page
15
15
15
15
15
32
32
15
32
32

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents