Yamaha RX-V2600 Owner's Manual page 126

TROUBLESHOOTING
Problem
The sound suddenly
goes off.
Only the speaker on
one side can be
heard.
Only the center
speaker outputs
substantial sound.
No sound from the
effect speakers
No sound from the
center speaker
No sound from the
surround speakers
No sound from the
surround back
speakers
No sound from the
subwoofer
122
Cause
The protection circuitry has been activated
because of a short circuit, etc.
The sleep timer has turned the unit off.
The sound is muted.
Incorrect cable connections.
Incorrect balance settings in the GUI
menu.
When playing a monaural source with a
CINEMA DSP program, the source signal
is directed to the center channel, and the
front and surround speakers output effect
sounds.
The sound field programs are turned off.
You are using a source or program
combination that does not output sound
from all channels.
The output level of the center speaker is
set to minimum.
Center is set to None in Speaker Set.
One of the HiFi DSP programs (except for
7ch Stereo) has been selected.
The output level of the surround speakers
is set to minimum.
Surround is set to None in Speaker Set.
A monaural or stereo source is being
played with STRAIGHT.
Presence speakers are selected.
Surround is set to None in Speaker Set.
Surround Back is set to None in Speaker
Set.
Bass Out is set to Front when a Dolby
Digital or DTS signal is being played.
Bass Out is set to SWFR or Front when a
2-channel source is being played.
The source does not contain low bass
signals.
Remedy
Check that the impedance selector setting is correct.
Check the speaker wires are not touching each other
and then turn this unit back on.
Turn on the power, and play the source again.
Press MUTE to cancel a mute.
Connect the cables properly. If the problem persists,
the cables may be defective.
Adjust the Speaker Level settings.
Press STRAIGHT (EFFECT) to turn them on.
Try another sound field program.
Raise the level of the center speaker.
Select the appropriate setting for the center speaker.
Try another sound field program.
Raise the output level of the surround speakers.
Select the appropriate setting for the surround left and
right speakers.
Press STRAIGHT (EFFECT) to turn on the sound
fields.
Select Surround Back in PR/SB Priority.
If the surround left and right speakers are set to None,
surround back speakers are automatically set to None.
Select the appropriate setting for the surround left and
right speakers.
Select Small x1, Small x2, Large x1 or Large x2.
Select SWFR or Both.
Select Both.
See
page
31
—
—
39
20
93
43
37
93
90
37
93
90
—
86
90
90
92
92