Setting Remote Control Codes - Yamaha RX-V2600 Owner's Manual

Setting remote control codes

You can control other components by setting the
appropriate remote control codes. Codes can be set up for
each input area. For a complete list of available remote
control codes, refer to "LIST OF REMOTE CONTROL
CODES" at the end of this manual.
The following table shows the default component
(Library: component category) and the remote control
code for each input area.
Remote control code default settings
Library
Input area (component
category)
A TAPE
XM TUNER
PHONO TV
TUNER TUNER
CD CD
MULTI CH
DVD
INPUT
V-AUX VCR
CBL/SAT CABLE
MD/TAPE MD
CD-R CD-R
DTV TV
VCR 1 VCR
DVR/VCR2 DVR
DVD DVD
Note
You may not be able to operate your YAMAHA component even
if a YAMAHA remote control code is preset as listed above.
In this case, try setting another YAMAHA remote control code.
1
Set AMP/SOURCE/TV to SOURCE.
AMP
SOURCE
TV
2
Press an input selector button to select the
source component you want to set up.
A XM AUDIO SEL SLEEP
PHONO TUNER CD MULTI CH IN
V-AUX CBL/SAT MD/TAPE CD-R
DTV VCR 1 DVR/VCR2 DVD
3
Default YAMAHA
code
2700
2604
–
2602
2300
4
2102
–
–
2500
2400
–
–
2807
2102
REMOTE CONTROL FEATURES
Press and hold LEARN for about 3 seconds
using a ballpoint pen or similar object.
The library name (ex. L;DVD) and the selected
component name (ex. DVD) appear alternately in the
display window.
LEARN
y
If you want to setup for another component, press the input
selector button or SELECT k / n to select the component.
Notes
• Be sure to press and hold LEARN for at least 3 seconds,
otherwise the learning process will start.
• If you do not complete each of the following steps within
30 seconds, the setting mode will be automatically
canceled. In this case, press LEARN again.
If you want to change a library (component
category), press l / h. You can set a
different type of component.
Library choices: L;DVD, L;DVR, L;LD, L;CD,
L;CDR, L;MD, L;TAP (tape), L;TUN (tuner),
L;AMP, L;TV, L;CAB (cable), L;SAT (satellite),
L;VCR
Notes
• The tuner library (L;TUN) code is preset in the TUNER
and XM buttons in order to operate this unit. The initial
settings for the TUNER and XM buttons are 2602 and
2604 respectively. However, you can switch the tuner
library code by entering one of the following codes if
necessary.
• The AMP library (L;AMP) code is preset to 2001 in order
to operate this unit. However, you can switch the AMP
library code by entering one of the following codes if
necessary.
105