Connecting The Antenna Cable To The Rf In Terminal; Antenna /Cable Connection - Panasonic TU-PTA500U Operating Instructions Manual

Installation
Connecting the antenna cable to the RF In Terminal
Antenna Connection - For proper reception of VHF / UHF channels, an external antenna is required. For best
reception an outdoor antenna is recommended. Antenna Mode must be set to this unit.
VHF Antenna UHF Antenna
/
I I I<_,_ ,_,11 I"l_,-o.,HI
L.{__ __ __ ,
r']....
f _-Ferrite sleeve (Supplies)
/L_
Antenna / cable connection
f
Installing the ferrite sleeve
Incoming Cable From Home Antenna (75 _)
VHF / UHF U ,L
on Back of Set
(.)
Cable Connection - For reception of cable channels (01 - 125)
connect the cable supplied by your local cable company. Antenna
Mode must be set to CABLE (Refer to Antenna Mode section.)
Incoming 75 _ Cable (From Cable Company)
VHF / UHF Ll II
on Back of Set
<2
(,)
Note:
Certain cable systems offset some channels to reduce interference
or have Premium (scrambled) channels. A cable converter box is
required for proper reception. Check with your local Cable company
for its compatibility requirements.
__ % ta_llsbaCkthe
(in two places)
3
Pass the cable
through and close
!,
(For a thick cable)
Pass the clamper
through the hole.
Clamper
Hole
,!,
Tighten the clamper to
secure the cable.
%,,
8