Accessories; Remote Control Battery Installation - Panasonic TU-PTA500U Operating Instructions Manual

I Installation
ACCESSORIES
Check the accessories before installations.
• Operating
Instruction book
TQBC0216
• Remote Control
Transmitter
EUR511164
• Battery for the Remote • Display Cable
Control Transmitter K1 HA26FA0001
(2 ×AA (IEC R6) size)
• Warranty Card
• Ferrite Core
TSK1027
©
r
Remote control battery installation
Requires two AA batteries.
1.
Turn the transmitter face down.
Remove top cover by pressing
down on marking and sliding
cover off in the direction
indicated.
\
\
2. Install the batteries as shown in
the battery compartment.
(Polarity + or - must match the
markings in the compartment).
Two AA size
3, Replace the cover and slide in
reverse until the lock snaps.
Helpful Hint:
For frequent remote control users,
replace old battery with Alkaline
batteries for longer life.
/_
Precaution on
battery
use
Incorrect installation can cause battery leakage and corrosion that will
damage the remote control transmitter.
Observe the following precautions:
1. Batteries should always be replaced as a pair. Always use new
batteries when replacing the old set.
2. Do not combine a used battery with a new one.
3. Do not mix battery types (example: "Zinc Carbon" with "Alkaline").
4. Do not attempt to charge, short-circuit, disassemble, heat or burn
used batteries.
5. Battery replacement is necessary when remote control acts
sporadically or stops operating this unit.
Helpful Hint:
Whenever you remove the batteries, you may need to reset the remote control infrared codes. We recommend
that you record the code on page 54 - 57, prior to setting up the remote.
6