Panasonic TU-PTA500U Operating Instructions Manual page 54

Operating peripheral equipment using the remote control
2. Setting to the remote using the step and set method
(When code not known):
1
+
IOL
CH
Press and hold the POWER and ACTION
keys simultaneously for three full
seconds
After 3 seconds, all the illuminated mode
keys will begin to flash Then let goolthe
POWER and ACTION key.
2
Press the mode key.
The mode key will illuminate steadily, all
_-_ _,_' _ others wlll go out,
3
C'4
'OL _ ,C;
OH
Press VOL" I.- " key to step to the next code
Press POWER to send a test signal rn
that format.
Continue doing this until the proper
device code is found. And the target
device responds.
4
OH
VOL_ V0L
CH
Once the code has been found, press the
ACTION key to lock it in.
Notes;
• The step and set mode will start from the current device (not the beglnn=ng
of the library, except for the first time).
• The step and set mode works in the reverse direction using the VOL " _ " key
Infrared Remote Codes for Specific Components
Helpful Hint: Write down the code numbers for your components in the space provided below This win serve as a
handy reference whenever you need to reprogram your remote control.
CABLE o_,o_o, I I !
DBS
Digdal Broadcast System I l I
I ! !
Ortl=tl ,,irlliS, , [
OIh_{ C r_f lll,<,r i,,r it
vc.
Video Cnssolte Recorder
RCVR
Rece=ver or Amphfler
co I I I
Compacl Disc Player
LD
I I I
CJll._r ( i ii#J i _rlt
54