Panasonic TU-PTA500U Operating Instructions Manual page 52

I SET UP for PC Input Signals
Press the MENU button to display the PC MENU screen, and select PC
MENU
CH
Vt:'L
¢H
Press to select each item.
Press to adjust.
SIGNAL
_'_NC ...... _;
PULL- N RANGE :II_[e_ :
CLAMP PQSITI(DN__
H-FREQ_ kHz
V-FREQ. _ Hz
CH'_NG_ _ SELECt
MENU
_- Press to end.
SYNC
Setting PC sync signal setting:
Confirm that the input is set to PC INPUT this setting is valid only for PC
INPUT).
H&V: TheHandVsyncsignalsarelnputfromtheHD/VDconnector
ON G: Uses a synchronized signal on the Video G signal, which is input
from the G connector.
SYNC H&V
SYNC
ON G
PULL IN RANGE
Sets the width for different frequencies.
PULL4NRANGE
POLL-IN RANGE
_ _ARROW _"
WiDE
CLAMP POSITION
Adjusts the clamp position.
The following operation methods are the same for "SIGNAL" menu
Normally, these adjustments are set to appropriate levels and therefore do
not need to be altered
H-FREQ (kHz) / V-FREQ
Displays the H (horizontal) / V (vertical) frequencies.
Display range:
Horizontal 15.5- 110 kHz
Vertical 48 120Hz
H FREO 31,5 kHz
V-FREQ 600 Hz
52