Connecting The Antenna Cable To The Rf In Terminal; Antenna / Cable Connection - Panasonic TU-PTA500U Operating Instructions Manual

Installation

Connecting the antenna cable to the RF In Terminal

Antenna Connection - For proper reception of VHF / UHF channels, an external antenna is required. For best
reception an outdoor antenna is recommended. Antenna Mode must be set to this unit.
VHF Antenna UHF Antenna
Mixer
75
Coaxial Cable

Antenna / cable connection

Incoming Cable From Home Antenna (75 )
VHF / UHF
on Back of Set
Cable Connection - For reception of cable channels (01 – 125)
connect the cable supplied by your local cable company. Antenna
Mode must be set to CABLE. (Refer to Antenna Mode section.)
Incoming 75 Cable (From Cable Company)
VHF / UHF
on Back of Set
Note:
Certain cable systems offset some channels to reduce interference
or have Premium (scrambled) channels. A cable converter box is
required for proper reception. Check with your local Cable company
for its compatibility requirements.
8
RF In Terminal
ANT AUDIO OUT
COMPONENT
VIDEO INPUT
1
2
DISPLAY OUT
AUDIO R - L P - P - Y VIDEO
R B
Ferrite sleeve (Supplies)
Installing the ferrite sleeve
1
3
Pass the cable
through and close
1
OUTPUT
PC-IN
1
INPUT
2
AUDIO R - L VIDEO S-VIDEO
2
Pull back the
tabs
(in two places)
(For a thick cable)
3
2
Pass the clamper
through the hole.
Clamper
Hole
Tighten the clamper to
secure the cable.
Open