Panasonic TU-PTA500U Operating Instructions Manual page 23

ASPECT Controls
Mode
Panasonic
AUTO
NORMAL
JUST
ZOOM
FULL
Picture
- 91
I
3 ,,_
l
For an elongated _mage
I- 4 --
I ii
For a 4:3 image
I-- 16---I
EPa_3_na s_°n 00 i9
oQ_ oil
Image is expanded
Changes in accordance
with the Panasomc
'_ AUTO mode setting
(see page 49)
-- 4 --I
d_ jo i
I-- 4 --I
3/---\ cj
( 13-1,
_16 --i
i- 4 --
!' ; /
/
i/
I-- 16 _,
;I _•-r_ ¸_ •' __T
3 ,-I, (:
Explanation
The display will automatically become enlarged
(depending on the picture source), allowing you to wew
the picture at its maximum size
Notes:
(1) Panasonic AUTO mode is designed to automatically
adjust the aspect ratio to handle a mix of 16:9 and
4:3 program material. Certain 4:3 program material,
such as stock market data screens, may
occasionally cause the _mage size to change
unexpectedly. When wewmg such programs, it is
recommended that the ASPECT be set to NORMAL.
(2) There may be a slight delay for the screen size to
adjust. If a 480p or 720p or 1080i signal is input
during component input signal mode, the controls
will not operate.
NORMAL will display a 4:3 picture at its standard 4:3
size.
JUST mode will display a 4:3 picture at its maximum
s_ze but with aspect correction applied to the center of
the screen so that elongation is only apparent at the
left and right edges of the screen. The size of the picture
wil! depend on the original signal.
ZOOM mode magnifies the central section of the picture•
FULL will display the picture at its maximum size but
with sight elongation
Note:
The screen s_ze also changes _f ID-1 =s detected
23