Table of Contents
Advertisement
Simple Setting Mode
<Operation>
[Simple setting mode (hysteresis mode)
In the simple setting mode, the set value, hysteresis and delay time can be changed while checking the
current pressure value (main display).
(1) Press and hold the
on the main display. When the button is released while in the [SEt] display, the current pressure value
is displayed on the main display, [P_1] or [n_1] is displayed on the sub display (left), and the set value
is displayed on the sub display (right) (Flashing).
(2) Change the set value with
setting moves to hysteresis setting. (The snap shot function can be used. (Refer to page 49.))
(3) Change the set value with
setting moves to the delay time of the switch output.
(The snap shot function can be used. (Refer to page 49.))
(4) Press the
or
Delay time setting can prevent the output from chattering.
(5) Press the
button for 2 seconds or longer to complete the OUT1 setting.
If the button is pressed for less than 2 seconds, the setting will be returned to P_1.
1: Selected items (1) to (4) become valid after pressing the
2: After enabling the setting by pressing the
button for 2 seconds or longer.
3: When the output mode (refer to page 28) is set to error output or output OFF, the simple setting mode cannot be used.
(The setting changes to measurement mode by releasing the button when [SEt] is displayed.)
button between 1 and 3 seconds in measurement mode. [SEt] is displayed
or
button, and press the
or
button, and press the
button, the delay time of the switch output can be selected.
button, it is possible to return to measurement mode by pressing the
-23-
button to set the value. Then, the
button to set the value. Then, the
button.
No.PS※※-OMS0007-D
Advertisement
Table of Contents
