Honda CB350 Repair Manual page 90

ENGINE AND TRANSMISSION 85
Neutral switch rotor in neutral position
from which they were removed. Install
the neutral switch to the end of the shift
drum.
2. Position the shift drum in the neu—
tral position (as seen by the neutral
switch) and install the neutral stopper
ball, spring, lockplate, and bolt. Bend the
lockplate up against the flat on the head
of the bolt.
3. 360 models: Install the shift fork
shaft, inserting it through the shift
Transmission shaft bearing set ring
Transmission assembly (350)
. Set ring
. Dowel pin
Ball bearing
Oil seal
Needle bearing
. Mainshaft fifth gear
. Mainshaft second and third gear
. Circlip
. Thrust washer
10. Mainshaft fourth gear
11. Mainshaft
12. Needle bearing
13. Countershaft first gear
14. Countershaft fourth gear
15. Countershaft third gear
16. Countershaft second gear
17. Countershaft fifth gear
18. Lockplate
19. Countershaft sprocket
20. Oil seal
21. Countershaft (complete)
22. O—ring
23. Countershaft
24. Bolt
25. Thrust washer
26. Lockwasher
27. Thrust washer
forks as it enters the case. Install the
guide pins and check that they fit into the
grooves in the shift drum.
4. Assemble the mainshaft and the
countershaft as shown in the accompany—
ing illustration. Install the transmission
shafts in the upper case. Be sure that the
shift forks are fitted to the proper gears.
Be sure that the bearings are fitted to the
set ring or the locating pins. When prop—
erly fitted the bearings should sit flush in
the case.