Honda CB350 Repair Manual page 109

104 FUEL SYSTEM
Hold the floats in place and install the
pivot pin. Install the float bowl.
4. Assemble the throttle slide.
5. Install the pilot air screw, turning it
in until lightly seated, then backing it out
the proper number ofturns as listed in
the chart at the end ofthis chapter.
6. After completing assembly, install
the carburetor on its manifold.
7. Check for fuel or air leaks; make
final adjustments to the throttle stop and
pilot air screws.
CONSTANT—VELOCITY TYPE
Removal and Installation
350 MODELS
1. Turn off the fuel supply at the pet—
cock and drain the float bowls. Discon—
nect the fuel lines at the petcock. Re—
move the fuel tank.
2. CL Models: Remove the exhaust
system.
3. Remove the plastic sidecovers and
the air cleaners.
Removing the cable adjuster bracket (350)
4. Loosen the connecting bands which
hold the carburetors to the intake mani—
fold. Remove the left carburetor from the
intake manifold and loosen the choke
band pinch—bolt, and slip the bandoffthe
shaft. Remove the cable stay and discon—
nect the cable from the throttle lever.
Remove the right carburetor and discon—
nect the throttle cable in the same man—
ner.
5. Installation is in the reverse order of
the above, however, note the following
points:
a. Connect the throttle cables before
mounting the carburetors;
b. Mount the right carburetor first,
then connect the choke band as the left
carburetor is installed;
c. Connect the fuel line from the
right carburetor to the rear outlet on
the petcock, and the fuel line from the
left carburetor to the front outlet. Se—
cure the fuel lines in place with a
spring clip;
d. Turn the fuel on and check for
leaks. Start the engine and check for air
leaks around the intake manifold and
air cleaner.
360 MODELS
1. Turn the fuel supply off at the pet—
cock and drain the float bowls. Discon—
nect the fuel lines at the petcock and
remove the fuel tank.
2. CL Models: Remove the exhaust
system.
3. Loosen the connecting bands which
secure the carburetors to the intake mani—
fold and air cleaner. Pull the carburetors
back toward the air cleaners until they
are free of the intake manifold, then re—
move them by lowering them out from
the left—side.
4. Disconnect the throttle cables from
the cable stay. Loosen the choke band
pinch—bolt and remove the choke band
from the left carburetor.
5. Remove the carburetors from the
mounting plate after—removing the four
mounting screws.
6. Installation is in the reverse order of
the above, but note the following points:
a. Connect the choke band to both
carburetors, tighten the pinch—bolt and
bend the locktab up against the nut on
the pinch—bolt;
b. Set the throttle lever to the stop
screw and install the coil spring as
shown in the accompanying illustra—
tion;
c. Mount the carburetors on the
mounting plate with the four mounting
screws;
d. Connect the throttle cables with
the throttles fully closed. The closing
cable is connected to the lower cable
stay and the opening cable is con—
nected to the top cable stay. Mount the