Honda CB350 Repair Manual page 50

ENGINE AND TRANSMISSION
45
Aage/ codominant
Top engine mount (350)
trol type carburetors, place the throttle
slides in a plastic bag secured with a rub—
ber band around the cable.
13. Disconnect the spark plug leads.
Loosen the spark plugs.
14. Remove the three bolts from the
top engine mount and remove the two
mounting plates.
15. Remove the nuts from the lower
engine mounting bolts. Remove the
starter motor cable from the rear mount—
ing bolts and remove all of the mounting
bolts. Note that the battery negative
cable will be completely disconnected
when the nut is removed from the upper
rear mount. It should be removed and
placed in a safe place.
16. Remove the engine, lifting it out of
the right—side of the frame.
17. Installation is the reverse ofthe re—
moval procedures; however, note the fol—
lowing points:
a. The starter motor cable is held in
place by two clamps fastened to the
rear engine mounting bolts;
b. The battery negative cable is fas—
tened to the upper rear mounting bolt
on the right—side. Be sure to clean all
dirt and paint from the frame so that the
cable may make a good ground;
c. A spacer is fitted between the
frame and the engine on the left front
mount (CB, CL models);
d. When connecting the drive chain
be sure that the opening in the mas—
terlink spring clip is facing the op—
posite direction of chain rotation;
e. Install the mounting bolts from
the right—side of the frame and the nuts
from the left;
f. Check that the steel ball is still in
Battery negative cable (arrow) and lower engine mounting bolts