Honda CB350 Repair Manual page 49

ENGINE AND TRANSMISSION
Disconnecting the alternator wiring
rear of the tank. Pull the tank up and back
to remove it from the front mounts.
6. Disconnect the alternator leads
from the wiring harness at the connector.
Disconnect the yellow and blue breaker
point leads from their connectors.
7. Remove the rear horn mounting
bolt and loosen the front bolt, tilt the
horn out of the way, as shown.
8. Disconnect the tachometer cable
from the engine after removing the phil—
lips head set screw.
9. Remove the stepbar (except SL
models) and gearshifter. Remove the four
screws from the countershaft sprocket
Move the horn out of the way before removing the
engine
Disconnecting the tach cable from the engine
cover and remove the cover with the
clutch cable still attached. Take care not
to lose the steel ball from the clutch re—
lease mechanism when removing the
cover.
10. Remove the masterlink from the
drive chain. Install the masterlink on one
end of the chain for safekeeping.
11. Disconnect the brake rod from the
brake pedal, remove the brake pedal
pivot bolt, and the brake pedal.
12. Loosen the connecting bands hold—
ing the carburetors to the intake manifold
and the air cleaners. Disconnect the
choke band from the right carburetor. Re—
move the carburetors and disconnect the
throttle cables. Refer to Chapter 6, "Fuel
System." On SL models with direct con—
Disconnecting the brake rod