Alesis PRIME User Manual page 9

1 6
6. Click
Press this button to turn the click on or off. Press and hold this button to view the
click settings listed below. To change the settings, tap the area to highlight the
field and turn the Main Encoder.
•
BPM: Use the Tempo button to set the BPM in this mode (20-999.)
•
Beats: Selects the number of beats in a measure. If this is set to 4, the first
beat will be articulation one, followed by three articulation twos (1-30).
•
Division: Select the note value of each beat, relative to the BPM (1/4, 1/4T,
1/8, 1/8T, 1/16, 1/16T, 1/32, 1/32T).
•
Sound: Select the preset sound that will be used for the click (Clap,
Metroclick, Drum Module Click, Shake, Sidestick 1, Sidestick 2, Tambourine,
Cowbell).
•
Output Volume: Sets the overall output volume for the click sound (-INF –
+6 dB). Double tap the Volume slider to reset the level to 0 dB.
•
Main Out 1/2: Selects the volume level that the click will be routed to Main
Out 1/2 (0-100). Double tap the Trim slider to reset the level to 80.
•
Headphones: Selects the volume level that the click will be routed to the
Headphones (0-100). Double tap the Trim slider to reset the level to 80.
•
Assign Out 3/4: Selects the volume level that the click will be routed to
Assign Out 3/4 (0-100). Double tap the Trim slider to reset the level to 80.
•
Assign Out 5/6: Selects the volume level that the click will be routed to
Assign 5/6 (0-100). Double tap the Trim slider to reset the level to 80.
7. Tempo
Press this button at least three times in succession to set the BPM.
1 7
9