Call Performance Test - Motorola iDEN i930 Field Service Manual

Advanced Features
The Advanced menu contains advanced and rarely used Settings features.
Call Alert Timeout — controls the amount of time a tone continues to sound when you receive
•
a message notification or call alert.
Headset/Speaker—If you use a headset or similar device with your phone, you can set your
•
phone to send incoming sound to the headset only, or to the headset and the speaker at the same
time:
1. From the main menu, select Settings > Phone Calls > Headset/Speaker.
2. Press the Ok button.
3. Scroll to Headset Only to send incoming sound to the headset only.
-or-
Scroll to Headset & Speaker to send incoming sound to the headset and the speaker at the
same time.
4. Press the Ok button.
Connectivity — Network ID sets the phone's network IDs and their roaming options under the
•
direction of your service provider; Master Reset lets your service provider to reset your service
in the event of a security or provisioning problem.
Reset Defaults — Reset Settings returns all settings to their original defaults; Reset All returns
•
all settings to their original defaults and erases all stored lists. Use only under the direction of
your service provider.
Return to Home — controls how long the recent calls list displays after calls.
•
Airplane Mode — User option to stop unit from receiving/transmitting radio frequency.
•
Settings > Flight Mode > OK > Off or On
Phone Only — prevents your phone from making or receiving Private calls or group calls.
•
BaudRate — sets the baud rate at which your phone communicates with a laptop computer, PC,
•
or similar device.
5.6.3

Call Performance Test

Use this test to verify the unit's ability to complete interconnect and dispatch calls.
NOTE: To prevent FM noise interference during testing, be sure to separate the test units by an
appropriate distance.
Required equipment: reference unit
The Call Performance test time is approximately 7 minutes:
1. Power up the unit. Wait until registration is complete before continuing.
2. Place an interconnect call from the problem unit to the reference unit.
3. Ensure that both units have a signal strength of 3 bars or more.
68P80401P03-O
BASIC LEVEL CHECKS AND SELF TESTS: Self-Test Procedures
5-11