Displays, Messages, And Alerts; Power-Up Sequence - Motorola iDEN i930 Field Service Manual

CHAPTER 3

DISPLAYS, MESSAGES, AND ALERTS

To conduct basic troubleshooting and maintenance of the i930 unit, you must become familiar with
the display screens, messages, and alert tones associated with the unit.
3.1

Power-Up Sequence

Extend the antenna whip and press the Power key until the power-up sequence begins. The power-
up sequence initiates a series of displays on the unit. Each display reflects a stage in the sequence.
If the last display shows the idle screen, the power up was successful; if the last display shows No
Service, the unit is out of range or there is a hardware or software problem.
If the vibrate function is enabled for incoming phone calls, voice mail, or message mail, the power-
up sequence includes a 500ms vibrate cycle.
Depending upon the service provider, the power-up sequence screens may differ from those shown.
1. Powering On Display
2. Insert SIM Display
3. Enable SIM PIN
Note: SIM PIN feature can be cancelled.
Refer to unit's Programming Menu.
68P80401P03-O
OR
Figure 3-1. Power-Up Sequence Displays
4. Connecting Display
5. No Service Display
OR
6. Unit Ready Display (Idle Screen)
Note: Idle screens differ depending on carrier.
3-1