Xerox Phaser 6180 User Manual page 136

Message
Paper JAM
RAM Disk Full
Press Set
Ready to Print
142-700
Over Heat
Turned Halfmode
Ready to Print
Non-GenuineToner
Reboot Printer
NNN-NNN
Reboot Printer
116-NNN
Reboot Printer
NNN-NNN
Reboot Printer
072-215
Reboot Printer
077-215
Reboot Printer
116-316
Reboot Printer
116-320
Condition/Reason/Action
Paper is jammed inside the printer.
Press the button to open the front cover and remove the jammed
paper. See Paper Jams
RAM disk memory is full and cannot continue processing the
current print job.
Press the OK button to clear the message, cancel the current print
job, and conduct the next print job, if any.
Press the Cancel button to cancel the print job.
Press the Left Arrow button to open the
menu and delete the current job.
To avoid this error in the future, do the following:
Reduce the number of print pages, such as splitting the print
data.
Increase free memory space by deleting unnecessary data in
the RAM disk.
The printer's internal temperature is too high.
Processing on the printer has been slowed down. When the
internal temperature falls, the processing speed will automatically
increase.
The printer is in the custom toner mode.
Though some of the print cartridges reach the end of their lives,
you can continue printing.
Error NNN-NNN relates to printer problems.
Turn the printer off and then on. If the error continues, refer to the
Xerox Support website, www.xerox.com/office/6180support.
Error NNN-NNN relates to printer problems.
Turn the printer off and then on.
The Multi-Protocol Network Card (optional) is not installed
correctly or is not working correctly due to damage or malfunction.
Reinstall the Multi-Protocol Network Card.
The 550-Sheet Feeder (optional) is not installed correctly or is not
working correctly due to damage or malfunction.
Reinstall the sheet feeder.
The Duplex Unit (optional) is not installed correctly or is not
working correctly due to damage or malfunction.
Reinstall the Duplex Unit.
Additional memory (optional) is not installed correctly or is not
working correctly due to damage or malfunction.
Reinstall the additional memory.
An unsupported additional memory (optional) is installed.
Replace the specified additional memory.
Phaser® 6180 Color Laser Printer
7-24
Control Panel Error Messages
on page 7-2.
Walk-Up Features