Table of Contents
Advertisement
Steps
1. Disconnect the power and data cable connector that is connected to the drive.
2. Press the release button, and slide the drive out of the drive slot.
Figure 28. Removing the cabled drive
Next steps
Replace the cabled
drive.
Installing a cabled drive
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
CAUTION:
Mixing drive carriers from other generations of PowerEdge servers is not supported.
NOTE:
When installing a drive into the drive carrier, ensure that the screws are torqued to 4 inch-pounds.
Steps
1. Insert the drive into the drive slot until the release button clicks into place.
2. Connect the power and data cable connector to the drive.
38
Installing and removing system components
Safety
instructions.
Before working inside your system.
Advertisement
Table of Contents
