Expansion Cards And Expansion Card Risers - Dell VCG3C Assembly, Installation And Service Manual

Figure 47. Installing the heat sink
Next steps
1. Follow the procedure listed in
2. While booting, press F2 to enter System Setup and check that the processor information matches the new system
configuration.
3. Run the system diagnostics to verify that the new processor operates correctly.

Expansion cards and expansion card risers

NOTE: When an expansion card riser is not supported or missing, the iDRAC and Lifecycle Controller logs an event. This
does not prevent your system from booting. However, if a F1/F2 pause occurs with an error message, see Troubleshooting
expansion cards section in the Dell EMC PowerEdge Servers Troubleshooting Guide at www.dell.com/poweredgemanuals.
54 Installing and removing system components
After working inside your system.