Adjusting The Anti-Scalp Rollers - Toro Z Master Professional 5000 Series Operator's Manual

Adjusting the Height-of-Cut Pin
The height-of-cut is adjusted from 25 to 140 mm (1
to 5-1/2 inches) in 6 mm (1/4 inch) increments by
relocating the clevis pin into different hole locations.
1. Move the transport lock to the lock position.
2. Push on the deck-lift pedal with your foot, and
raise the mower deck to the transport position
(also the 140 mm (5-1/2 inches) cutting height
position) as shown in
3. To adjust, rotate the pin 90 degrees and remove
the pin from the height-of-cut bracket
27).
4. Select a hole in the height-of-cut bracket
corresponding to the height-of-cut desired, and
insert the pin (Figure
5. Push on the deck lift, pull back on the transport
lock, and slowly lower the mower deck.
Figure 27
1. Deck-lift pedal
2. Cut-of-height pin
Figure 27.
(Figure
27).
3. Transport lock
Adjusting the Anti-Scalp
Rollers
Whenever you change the height-of-cut, it is
recommended to adjust the height of the anti-scalp
rollers.
1. Disengage the blade-control switch (PTO), move
the motion-control levers to the N
position, and engage the parking brake.
2. Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3. Adjust the anti-scalp rollers as shown in
28, Figure
1. Anti-scalp roller
2. Spacer
3. Bushing
g027343
1. Anti-scalp roller
2. Bushing
26
29, and Figure 30.
Figure 28
4. Flange nut
5. Bolt
Figure 29
3. Flange nut
4. Bolt
-
EUTRAL LOCK
Figure
g000942
g000943