Table of Contents
Advertisement
4.
Place 4 blocks, each having a thickness of
7.3 cm (2-7/8 inches), under the rear and front
edges of the mower deck. Ensure to not place
the blocks under the anti-scalp rollers or welds.
Figure 92
Bottom view
1. Block—73 mm (2-7/8
inches)
5.
Set the height-of-cut lever to the 76 mm (3
inches) position.
6.
Carefully rotate the blades side to side.
g402248
g038090
2. Welds
7.
Loosen the locknuts on all 4 corners of the
deck and ensure that the mower deck is sitting
securely on all 4 blocks.
1. Chain
8.
Remove any slack from the deck chains and
ensure that the deck-lift foot lever is pushed
back against the stop.
9.
Tighten the 4 locknuts.
10.
Ensure that the blocks fit snugly under the deck
skirt and that all attachment bolts are tight
11.
Check the mower deck side-to-side level and
blade slope; repeat this procedure as necessary.
12.
Raise the deck to the transport position (140 mm
or 5-1/2 inches).
13.
Install any removed anti-scalp rollers.
52
Figure 93
2. Bolt and locknut
g402249
Advertisement
Table of Contents
