Performance Tables - Xerox DocuPrint 65 Operator's Manual

Operator Guide

Performance tables

Symbols
Characters
DocuTech 65/DocuPrint 65
In the printer performance tables, various symbols and characters are used to
convey information.
The following symbols in the "Rating" column of a table represent the
expected paper handling and image quality performance in typical operating
environments.
l = Best performance
o = Good performance
o = Fair - Good performance
x = Not recommended. Exceeds design specifications. Unacceptable
performance is likely.
** = Indicates the same performance as shown in Tables 3-2 and 3-3 for the
corresponding paper sizes.
The following characters in the "Note" column of a table provide additional
information.
a = Cannot be duplexed.
b = The output will go to the Top Tray and cannot be stapled.
c = Requires a Xerox technical specialist to permanently set up any of the
trays 1-4 to handle 12 x 18-inch (305 x 457 mm) paper. After any one of these
trays is set up to handle this size, it cannot run other sizes. Tray 5, however,
can be used without any special set-up intervention from Xerox.
d = For the correct paper loading orientation refer to the paper tray label or to
Table 3-6.
e = Embossed letterhead may cause degraded paper handling, and possibly
minor image deletion defects near the embossed area on either side of the
paper.
f = Although the carbonless paper might feed through the printer, the fusing
process is likely to cause dry ink contamination on subsequent pages or jobs.
g = Performance is highly dependent on the quality of the coated paper.
Frequent use of coated papers, especially lower quality papers, might cause
increased contamination in the printer which could degrade the paper
handling capability and the image quality performance for all papers.
h = Image deletion defects might occur near the perforation, especially if the
perforation is parallel to the feed direction.
i = Two-sided printing (duplex) should not be selected when this stock is used.
j = It is recommend that only Bypass Tray (Tray 5) is used for this stock.
k = Blank or preprinted covers are acceptable. Cannot print on textured cover
stock.
l = The 110 lb index stock (203 gsm) and the 65 lb cover stock (244 gsm) are
both used for covers on documents. The paper handling performance for both
stocks will be similar.
Paper and other stock
3-5