Table of Contents
Advertisement
Securing a child restraint seat with
"Tether Anchor" system
Child restraint hook holders are located
on the floor behind the rear seats.
OYN039020
1. Route the child restraint seat strap
over the seatback.
For vehicles with adjustable head
restraint, route the tether strap under
the head restraint and between the
head restraint posts, otherwise route
the tether strap over the top of the
seatback.
2. If your vehicle is equipped with a lug-
gage board, set the board to the low-
est position.
3. Open the tether anchor cover.
4. Connect the tether strap hook to the
appropriate child restraint hook holder
and tighten to secure the seat.
Safety features of your vehicle
WARNING
A child can be seriously injured or
killed in a collision if the child
restraint is not properly anchored
to the car and the child is not prop-
erly restrained in the child restraint.
Always follow the child seat manu-
facturer's instructions for installa-
tion and use.
OJC030021
WARNING
Never mount more than one child
restraint to a single tether or to a
single lower anchorage point. The
increased load caused by multiple
seats may cause the tethers or
anchorage points to break, causing
serious injury or death.
CAUTION
A Child Restraint System in a
closed vehicle can become very
hot. To prevent burns, check the
seating surface and buckles before
placing
your child in the Child
Restraint System.
-
Tether strap
3 33
Advertisement
Table of Contents
