Table of Contents
Advertisement
9) Switch off the compressor.
10) Detach the hose from the
sealant bottle connector and
from the tyre valve.
Return the Tyre Mobility Kit to its
storage location in the vehicle.
WARNING
Carbon monoxide poisoning
and suffocation is possible if the
engine is left running in a poorly
ventilated or unventilated loca-
tion (such as inside a building).
Distributing the sealant
Immediately drive approximately 3 km
(2 miles) to evenly distribute the
sealant in the tyre.
CAUTION
Do not exceed a speed of 80
km/h (50 mph). If possible, do
not fall below a speed of 20
km/h (12 mph).
Whilst driving, if you experience
any unusual vibration, ride dis-
turbance or noise, reduce your
speed and drive with caution
until you can safely pull off of
the side of the road.
Call for road side service or tow-
ing.
What to do in an emergency
Producing the tyre inflation pres-
sure
1) After driving approximately 3 km (2
miles), stop at a suitable location.
2) Connect the filling hose 2 of the
compressor (clip mounted side)
directly and then connect the filling
hose 2 (opposite side) to the tyre
valve.
3) Connect between compressor and
the vehicle power outlet using the
cable and connectors.
4) Adjust the tyre inflation pressure to
220 kPa (32 psi). With the ignition
switched on, proceed as follows.
- To increase the inflation pres-
sure: Switch on the compressor,
position I. To check the current
inflation pressure setting, briefly
switch off the compressor.
WARNING
Do not let the compressor run for
more than 10 minutes, otherwise
the device will overheat and may
be damaged.
6 27
Advertisement
Table of Contents
