Table of Contents
Advertisement
Changing a tyre with TPMS
If you have a flat tyre, the low Tyre
Pressure and Position telltales will
come on. We recommend that the
system be checked by a HYUNDAI
authorised repairer.
CAUTION
We recommend that you use a
puncture-repairing
approved by HYUNDAI. The
sealant on the tyre pressure
sensor and wheel shall be elim-
inated when you replace the
tyre with a new one.
Each wheel is equipped with a tyre
pressure sensor mounted inside the
tyre behind the valve stem. You must
use TPMS specific wheels. It is rec-
ommended that you have your tyres
serviced by a HYUNDAI authorised
repairer.
After you replace the low pressure
tyre with the spare tyre, the TPMS
malfunction indicator may blink for
approximately 1 minute and then
remain
continuously
because the TPMS sensor mounted
on the spare wheel is not initiated.
Once the low pressure tyre is rein-
flated to the recommended pressure
and installed on the vehicle or the
agent
TPMS sensor mounted on the
replaced spare wheel is initiated by a
HYUNDAI authorised repairer, the
TPMS malfunction indicator and the
low tyre pressure and position tell-
tales will extinguish within a few min-
utes of driving.
If the indicator is not extinguished
after a few minutes of driving, we
recommend that the system be
checked by a HYUNDAI authorised
repairer.
What to do in an emergency
CAUTION
If original mounted tyre is
replaced with the spare tyre, the
TPMS sensor on the replaced
illuminated
spare wheel should be initiated
and we recommend that the
TPMS sensor on the original
mounted wheel be deactivated
by a HYUNDAI dealer. If the
TPMS sensor on the original
mounted wheel located in the
spare tyre carrier still activates,
the tyre pressure monitoring
system may not operate proper-
ly. We recommend that the sys-
tem be serviced by a HYUNDAI
authorised repairer.
6 37
Advertisement
Table of Contents
