Table of Contents
Advertisement
Installation, cont'd
Through-furniture mounting the switcher
The switchers can be mounted through a desk or other furniture. The SW2 models require an
optional through-desk mounting kit, part #70-077-02. The SW4 and SW6 models require the
included through-desk and rack mounting bracket. Mount the switcher as follows (figure 2-4):
Figure 2-4 — Through-desk mounting
1.
2.
3.
4.
5.
6.
7.
2-6
SW RGBHV Series Switchers • Installation
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Loosely attach the mounting brackets to the switcher using the four supplied
machine screws and washers. On the SW4 and SW 6 models, use two screws
on each side, inserted through the slotted holes on the brackets (figure 2-2).
Hold the switcher underneath the surface where it will be mounted. Mark the
cutout area and four screw holes on the underside of the surface.
Cut out the surface material that you marked in step 2.
Insert the switcher into the hole to test the fit. If necessary, use a rasp to
enlarge the cut-out.
Drill four pilot holes, 3/32" in diameter by 1/4" deep, at the screw marks.
Attach the brackets to the mounting surface with the four wood screws
provided.
Slide the switcher up and down or back and forth in the mounting brackets
until the face of the switcher is at the desired height. Tighten the screws that
secure the bracket in place.
If the screws are inaccessible to a screwdriver:
a.
Mark the location of the brackets relative to the screws.
b.
Remove the switcher from the underside of the surface.
Advertisement
Table of Contents
