Http - Xerox WorkCentre 4118 System Administration Manual

HTTP

Use these instructions to setup HTTP using CentreWare Internet Services.
NOTE: The HTTP settings for the device will have been setup when completing the
Enabling CentreWare Internet Services section.
To complete the installation of the device, perform these steps:
Enable CentreWare Internet Services (see "Enabling Internet Services" on page 7-5).
1
At the CentreWare Internet Services Home Page for the WorkCentre 4118, select the
3
[Properties] tab.
Select the plus symbol [+] to the left of the Connectivity folder in the Properties frame, and
4
then select the [+] symbol to the left of the Protocol folder.
Check the
5
Enter the [Keep Alive Timeout] in seconds from 5 to 99.
Enter the [Maximum Connections] from 5
Click the [Apply] button to implement any changes.
6
NOTE: Click the [Undo] button to cancel any changes made and return to the
previous values.
Select the [Status] tab and then select [Reset Network Controller] to enable the selections
7
to take effect.
Continue with Test Print.
8
Page 7-22
HTTP Configuration details are correct. If necessary.
to 32.
Xerox WorkCentre 4118 System Administration Guide