Xerox WorkCentre 4118 System Administration Manual page 56

6 6
Press
displays and press [Enter].
7
Press
displays and press [Enter].
8
Press
displays and press [Enter].
9
To enable or disable LPD/LPD,
press
required setting, [Enable] or
[Disable] displays, enter the port
number using the keyboard and
press [Enter].
NOTE: While you can change the port number at which the WorkCentre 4118 will
accept LPR print jobs, it is recommended that you do this ONLY with extreme
caution as most LPR spoolers are set to send print jobs to the default port number,
515. To change Port number see "Using CentreWare Internet Services" on page 7-
3.
Page 6-4
or until TCP/IP
or until Manual
or until LPD/LPD
or until the
Config Network
[TCP/IP]
TCP/IP
[Manual]
Manual
[LPD/LPD]
LPD/LPD
[Enable]
Xerox WorkCentre 4118 System Administration Guide