Dynamic Methods Of Setting The System's Ip Address - Xerox Phaser 8560MFP User Manual

Dynamic Methods of Setting the System's IP Address

Set the system's IP address using any of the following methods. DHCP is enabled by default
on all Phaser printers.
■ DHCP
■ CentreWare IS
■ AutoIP
Information Required for Manual IP Addressing
Information
Internet Protocol (IP) address of the system
Network Mask
Default Router/Gateway address
Enabling DHCP on the System
Verify that the system DHCP protocol is enabled by setting the control panel or by using
CentreWare IS. DHCP is enabled by default.
Note: To determine the system's IP address, select
panel, press the System button, select
, and then press the OK button to view the system's IP address.
Identification
See also:
Control Panel Features
Phaser® 8510/8560MFP Multifunction Product
Comments
Format is xxx.xxx.xxx.xxx, where xxx represents
a decimal number from 0–255.
If you are unsure, leave this blank; the system
chooses an appropriate mask.
Router address is required to communicate with
the host device from anywhere other than the
local network segment.
System Identification
, press the OK button, select
Information
on page 1-8
2-6
Configuring the Network Address
. On the control
System