Dynamic Methods Of Setting The Printer's Ip Address - Xerox Phaser 8510 User Manual

Dynamic Methods of Setting the Printer's IP Address

Set the product's IP address using any of the following methods. DHCP is enabled by default
on all Phaser printers.
■ DHCP
■ CentreWare IS
■ AutoIP
Information Required for Manual IP Addressing
Information
Internet Protocol (IP) address of the product
Network Mask
Default Router/Gateway address
Enabling DHCP on the Printer
Verify that the product DHCP protocol is enabled by setting the control panel or by using
CentreWare IS. DHCP is enabled by default.
Note: To determine the product's IP address, select
panel, press the System button, select
, and then press the OK button to view the product's IP address.
Identification
See also:
Control Panel Features
Phaser® 8560MFP/8860MFP Multifunction Printer
Comments
Format is xxx.xxx.xxx.xxx, where xxx represents
a decimal number from 0–255.
If you are unsure, leave this blank; the product
chooses an appropriate mask.
Router address is required to communicate with
the host device from anywhere other than the
local network segment.
, press the OK button, select
Information
on page 1-10
2-6
Configuring the Network Address
. On the control
Product Identification
Product