Manually Setting The System's Ip Address - Xerox Phaser 8560MFP User Manual

Manually Setting the System's IP Address

Note:
Verify that your computer has a properly configured IP address for your network.
Contact your network administrator for more information.
If you are on a network without a DNS server, or in an environment where the network
administrator assigns system IP addresses, you can use this method to manually set the IP
address. Manually setting the IP address overrides DHCP and AutoIP. Alternatively, if you are
in a small office with a single PC and use a dialup modem connection, you can manually set
the IP address.
1. On the control panel, press the System button.
2.
Select Connection Setup
3. Select
Network Setup
4.
Select TCP/IP Setup
5. Select
DHCP/BOOTP
6. Select
TCP/IP Address
7.
Enter the system's IP address, and then press the OK button.
See also:
Advanced Features Guide at
Phaser® 8510/8560MFP Multifunction Product
, and then press the OK button.
, and then press the OK button.
, and then press the OK button.
, select , and then press the OK button.
Off
, and then press the OK button.
www.xerox.com/office/8510_8560support
2-9
Configuring the Network Address