Output Control - Miller Maxstar 300 LX Owner's Manual

5-7.

Output Control

1 Output Control
Press switch pad until desired param-
eter LED is illuminated.
RMT STD (Remote Standard)
Application: Use Remote Trigger
(Standard) with a foot pedal or finger
amperage control (see Section 6-2A).
NOTE: When a foot or finger remote
current control is connected, initial
amps, initial slope, final slope, and fi-
nal amps are controlled by the remote
1
control.
NOTE: If an On/Off type trigger is
used, it must be a maintained switch.
All Sequencer functions become ac-
tive, and must be set by the operator.
RMT 2T HOLD
Application: Use Remote Trigger
Hold (2T) for long extended welds.
If a foot or finger current control is con-
nected to the welding power source,
only trigger input is functional (see
Section 6-2B).
NOTE: This switch function can be re-
configured for 4T, 4T Momentary, Mini
Logic, or Spot control See Section
6-2C)
ON
Output will energize two seconds after
being selected.
Application: Use Output On for Stick
(SMAW) welding, or for Lift-Arc with-
out the use of a remote control (see
Section 6-2I).
OM-2222 Page 27