Miller Maxstar 300 LX Owner's Manual page 51

B. LockOut Levels
Level 1
Use Output Switch Pad To
Select A Trigger Method
For The TIG Process
Use Output Switch Pad To
Select A Trigger Method
For The Stick Process
Level 2
Select Process
Process Selection
NOTE: Before activating lock out
levels, be sure that all procedures
and parameters are established.
Level 1
NOTE: Remote amperage control
is not available in level 1.
TIG Output Selection
If either TIG HF Impulse or TIG Lift
Arc process (see Section 5-6) is ac-
tive when lockout level 1 is acti-
vated, the operator can choose
RMT STD (Remote Standard) or
RMT 2T HOLD (Remote 2T Hold).
The On function is available if TIG
Lift Arc is active.
If RMT 2T HOLD was reconfigured
(see Section 6-2C) prior to lockout
level 1 activation, the reconfigured
output mode (4T, 4T momentary,
mini logic, or spot) is available
instead of RMT 2T.
Stick Output Selection
If the Stick process is active when
lockout level 1 is activated, choose
between RMT STD or On.
When parameter choice or selec-
tion is limited by lock level 1, [L-1 ] is
displayed.
Level 2
NOTE: Remote amperage control
is not available in level 2.
Includes all the functions of level 1
plus Process Selection (see Sec-
tion 5-6).
When parameter change or selec-
tion is limited by lock level 2, [L-2] is
displayed.
OM-2222 Page 45