Xerox Document Centre 240 Reference Manual page 296

Problem Symptom
Paper Repeated Check Tray
Handling Messages on the User
Interface and the paper is
(cont'd)
loaded in the tray
Paper Curls
The Finisher does not stack
the output correctly
Page 15 - 8
Recommendation
l
Adjust the edge guides against the stack of
paper in the tray.
l
If the edge guides were not set against the
paper stock in the tray when Start was
selected, delete the job in the job queue and
begin again.
l
Load the paper in the paper trays seam side
of the paper up. Load the paper in the High
Capacity Feeder and Bypass Tray with the
seam side down.
The seam refers to the side of a
ream of paper with a split in the
wrapping. It may also be
referred to as arrow side first.
l
Load non-standard media in the Bypass
Tray.
l
If the paper curls excessively, flip the paper
over in the applicable paper tray.
l
Unload the finisher tray frequently.
Depending on your machine configuration
there may be a pause button on the side of
the finisher.
l
Do not remove stapled sets while the
finisher is compiling.
Xerox Document Centre Reference Guide