Table of Contents
Advertisement
MXA920
Ceiling Array Microphone
Getting Started
Designer Setup Example
This example uses Designer 6.0 to connect an MXA920 and a P300. The process is similar when using other combinations of
devices in Designer, so use these steps as a starting point.
After completing this basic setup process, you should be able to:
•
Discover the MXA920 in Designer
•
Add coverage areas
•
Adjust DSP settings and route audio
•
Understand the basic workflow for working with devices in Designer
This example uses:
•
Cat5e (or better) Ethernet cable (shielded cable recommended)
•
Network switch
that provides Power over Ethernet (PoE) and PoE+ for the P300
•
Shure Designer software installed on a computer. Download at shure.com/designer.
•
P300
Step 1: Install and Connect
1.
Install the MXA920
and other devices. Connect the MXA920 to a PoE port and the P300 to a PoE+ port on the switch
using Ethernet cable.
2.
Connect your computer running Designer to the same network.
3.
Open Designer. Check that you're connected to the correct network in File > Designer preferences.
4.
Open a new design and drag all devices into the design.
Shure Incorporated
4/50
Advertisement
Table of Contents
Troubleshooting
