KTM 350 EXC-F 2024 Owner's Manual page 111

Main work
–
Check the wheel bearing for damage and wear.
» If the wheel bearing is damaged or worn:
–
Change the rear wheel bearing.
–
Clean and grease shaft seal rings
of the spacers.
Long-life grease (
–
Insert the spacers.
H03001-10
–
Clean and lightly grease the wheel spindle.
Long-life grease (
–
Position rear wheel and insert wheel spindle
The brake linings are correctly positioned.
–
Mount the chain.
V00367-10
–
Position chain adjuster
it yet.
–
Make sure that chain adjusters
adjusting screws
–
Check the chain tension. (
–
4
Tighten nut
Guideline
Nut, wheel spindle,
rear
Info
The wide adjustment range of the chain adjusters
(32 mm (1.26 in)) enables different secondary ratios
with the same chain length.
Chain adjusters
–
Operate the foot brake lever repeatedly until the brake lin-
ings are in contact with the brake disc and there is a pressure
point.
V00368-10
Finishing work
–
Remove the motorcycle from the lift stand. (
1
and contact surfaces
p. 160)
p. 160)
3 4
. Mount nut , but do not tighten
3
are fitted correctly on
5
.
p. 83)
.
M22 80 Nm (59 lbf ft)
3
can be turned by 180°.
WHEELS, TIRES 14
A
2
.
p. 60)
109