System Preference - Session Tab - Wyse Winterm S10 User Manual

30
Chapter 3
•
•
Figure 11 System Preference - Session tab
•
•
Delay before repeat - Repeat parameters for held-down key. Select the Delay before
repeat (either 1/5 second, 1/4 second, 1/3 second, 1/2 second, 1 second, 2
seconds, or No Repeat). The default is 1/3 second.
Repeat Rate - Select Slow, Medium, or Fast. The default is Medium.
Note
Default settings are not active to connections saved in NV-RAM, but do effect
new connections immediately and other connections upon system restart
and log-on.
Settings common to all sessions - Select the check boxes you want for the options
that are available to all sessions. (The Smart Card check box specifies the default
setting for connecting to a smart card reader at startup.)
Note
ICA sessions always have automatic connection to attached smart card
readers, while RDP connections require use of the Smart Cards check box.
When using the Disks check box for automatic connection to connected
USB sticks, use the following guidelines:
- Support is for VFAT File System only, be sure that the USB stick you use is
formatted to FAT16 or FAT32.
- More than one disk can be used at the same time, however, the maximum
number of USB sticks (including different subareas) is 12.
- It recommended that you use Windows XP, Windows Server 2003, or
Windows Server 2008 for the ICA or RDP server.
- Be sure to save all data and log off from the ICA or RDP session mapping
the USB stick before removing the USB stick.
Settings common to all ICA sessions - Select the check boxes you want for the
options that are available to all ICA sessions.