Configuring Dual Monitor Settings - Wyse Winterm S10 User Manual

40
Chapter 3
Use the following guidelines:
•
•
•
•

Configuring Dual Monitor Settings

(Supported Dual Monitor Capable Thin Clients Only) The DualHead Setup dialog box
allows you to configure the way two monitors display.
Figure 22 DualHead Setup
Select best display setting on DDC monitor - If the monitor is VESA DDC2B
(Display Data Channel) compatible, selection of this option allows the thin client to
automatically select the best resolution and refresh rate. If your monitor is not DDC
compatible, a Monitor does not support Plug and Play message is displayed (click OK
to acknowledge the message and remove it from the screen).
DDC table - If the monitor is VESA DDC2B (Display Data Channel) compatible,
selection of this option allows you to select the resolution and refresh rate you want
from the list.
User defined display setting - Select this option and select the resolution and refresh
rate supported by your monitor (all combinations are allowed):
• Resolution list selections include:
640 x 480
800 x 600 (default)
1024 x 768
1280 x 1024
1360 x 768
1400 x 1050
1440 x 900
1600 x 1200
1680 x 1050
1920 x 1080
1920 x 1200
• Refresh rate list selections include:
60 Hz (default)
75 Hz
85 Hz
Usage Help area - Contains brief instructions for using the Display Setup dialog box
and running the test. No operator entry can be made in this box. Make note of the
instructions in the area regarding v-key reset usage in case of display failure.
Use the following guidelines:
• Dual Head - Select Disable to have the two monitors work in a matching state, or
Enable to have the two monitors work separately (second is extended from first).