Network Setup - Security Tab - Wyse Winterm S10 User Manual

36
Chapter 3
Figure 17 Network Setup - Security tab
Use the following guidelines:
•
•
•
•
Network Mode - Select either the Wired LAN or Wireless option.
Access Type - (For Wireless Option Only) Select the access type option (either None,
WPA_Personal, WPA2_Personal, WPA_Enterprise, or WPA2_Enterprise) to be
used for this wireless communication link.
WPA_Personal and WPA2_Personal - Wi-Fi Protected Access (WPA)_Pre-Shared
Key (PSK) encryption can be enabled by selecting one of these options (WPA was
designed to improve upon the security features of WEP; WPA2 provides government
grade security).
WPA_Enterprise and WPA2_Enterprise - Wi-Fi Protected Access (WPA)_Enterprise
encryption can be enabled by selecting one of these options (WPA2-Enterprise verifies
network users through a server. WPA2 is backward compatible with WPA).
Enable IEEEE 802.1x authentication - Select this check box to enable this
authentication and activate the EAP Type list of options.
EAP Type - If you have enabled the Enable IEEEE 802.1x authentication check box,
select the EAP Type option you want (TLS, LEAP, or PEAP).
• TLS - If you select the TLS option, click Properties to open and configure the
Authentication Properties dialog box (you can use Browse to find and select the
Client Certificate file and Private Key file you want). Note that the CA certificate
must be installed in the device.
• LEAP - If you select the LEAP option, click Properties to open and configure the
Authentication Properties dialog box (be sure to use the correct Username and
Password for authentication). Note that the maximum length for the username or
the password is 64 characters.
• PEAP - If you select the PEAP option, click Properties to open and configure the
Authentication Properties dialog box (be sure to select either EAP_GTC or
EAP_MSCHAPv2, and then use the correct Username, Password, and Domain, if
necessary, for authentication). To configure EAP-GTC, enter the username only,
and the password or PIN will be asked when authenticating. To configure
EAP-MSCHAPv2, enter the username, password, and domain (domain\username
in the username box is supported, but you must leave the domain box blank). Note
that the CA certificate must be installed in the device (the server certificate is forced
to be validated).