Wyse Winterm S10 User Manual page 53

Setting Up the Thin Client
Figure 26 Printer Setup - SMBs tab
Use the following guidelines:
• Select SMB - Select the SMB you want from the list.
• Printer Name - Enter the printer name.
• Printer Identification - Enter the type or model of the printer. This name should be
either the device driver name for the printer under the Microsoft Windows system, or a
key to map to the device driver. If not specified, the name will be defaulted to the
printer-supplied identification for standard direct-connected USB printers or Generic /
Text for non-USB or serial-connected printers upon connection to Windows hosts. The
driver name mapping takes place either through a printer-mapping file read by the
system as part of the Global system profile (wnos.ini) or by MetaFrame servers through
the MetaFrame printer configuration file (\winnt\system32\wtsprnt.inf).
In an ICA environment, it is recommended that administrators use the wtsprnt.inf file to
define printer driver mapping to maintain the consistency of usage from various ICA
client devices. In an RDP environment, administrators should use the wnos.ini file to
define printer driver mapping. If there is no mapping file, or if the mapping entry for the
printer is not found, the identification must be a supported driver name on the
connected hosts for the printer to be automatically created on the hosts.
• \\Host\Printer - Enter the Host\Printer or use Browse next to the box to make the
selection you want.
• Printer Class - Select the printer class from the list.
• Enable the printer device - Must be selected to enable the directly-connected printer.
• Enable LPD service - Select this to make the thin client an LPD (Line Printer Daemon)
server for LPD printing requests from the network (for more information refer to
"Configuring LPD Services."
45