Wolf DD30I Installation Instructions Manual page 3

W O L F D OW N D R A F T
I N S TA L L AT I O N R E Q U I R E M E N T S
IMPORTANT NOTE: This installation must be
completed by a qualified installer or Wolf
authorized service center technician.
Installer: Please read the entire Installation
Instructions prior to installation. Save these
instructions for the local inspector's refer-
ence, then leave them with the homeowner.
Homeowner: Please read and keep these
instructions for future reference and be sure
to read the entire Use & Care Information
prior to use.
Any questions or problems about the
installation should be directed to your Wolf
dealer or Wolf Appliance Company, Inc. at
800-332-9513. You can also visit our website
at wolfappliance.com.
IMPORTANT NOTE: This appliance must be
installed in accordance with National Electrical
Codes, as well as all state, municipal and local
codes. The correct voltage, frequency and
amperage must be supplied to the appliance
from a dedicated, grounded circuit which is
protected by a properly sized circuit breaker or
time delay fuse. The proper voltage, frequency,
and amperage ratings are listed on the product
rating plate.
Record the model and serial numbers before
installing the downdraft ventilation system.
Both numbers are listed on the rating plate,
located above the airbox on the front side of
the unit. Refer to the illustration below.
Location of
rating plate
Rating plate location
V E N T I L AT I O N S Y S T E M S
B E F O R E Y O U S T A R T
Proper installation is the responsibility of
the installer. Product failure due to
improper installation is not covered under
the Wolf Warranty. Refer to the Downdraft
Ventilation Use & Care Information for
warranty details, or visit our website,
wolfappliance.com.
Check with local utilities for electrical codes
that apply in your area. Local codes vary.
Installation, electrical connections and
grounding must comply with applicable
codes. In the absence of local codes, this
appliance should be installed in accordance
with National Electrical Code ANSI/NFPA
70-1990 or latest edition.
This appliance must be properly grounded.
Refer to Electrical Requirements on
page 8.
Make sure you have the tools and materials
necessary for proper installation.
Any required service must be performed by
a Wolf authorized service center. Wolf is not
responsible for service required to correct a
faulty installation.
R AT I N G P L AT E
I N F O R M AT I O N
Model Number
Serial Number
3