Wolf DD30I Installation Instructions Manual page 12

W O L F
D O W N D R A F T
C U T T H E C O U N T E R T O P
Lay out and cut the cooktop cut-out far
enough forward so the downdraft will fit
behind it.
Set the cooktop in place and slide it as far
forward as possible. Center and square the
cooktop with edges of countertop.
Place the plastic template included with the
downdraft against the back flange of the
cooktop and centered. Trace around the
template to mark the downdraft opening.
Remove the cooktop from countertop.
Cut the downdraft opening. Be careful not
to chip the edges of the countertop.
12
D OW N D R A F T V E N T I L A T I O N S Y S T E M S
I N S TA L L AT I O N
M O U N T T H E U N I T
Set the downdraft into the opening. Extend
the leveling brackets to the floor of the
cabinet so the downdraft sits straight.
NOTE: The leveling brackets can be
removed and reattached in other positions.
The flange of the leveling bracket may have
to face inward in tight cabinet installations.
Refer to the illustration below.
Secure the downdraft to the countertop by
holding the downdraft against the back of
the countertop cut-out and tightening the
two mounting screws (one on each end of
unit) on the underside of the countertop.
Screw the leveling brackets to the bottom
of the cabinet. Tighten the screws holding
the leveling brackets to unit on each side.
C O N N E C T T H E C O N T R O L M O D U L E
Connect the RJ45 connector cable to the back
side of the remote-mounted control module.
Connect the other end of the cable to the
electrical connection located on the right
side of downdraft assembly. Make sure that
all connections are tight.
Refer to the illustration on the front of the
downdraft for the correct orientation of the
RJ45 connector during installation into the
downdraft assembly.
leveling bracket –
flange facing out
leveling bracket – flange facing in
Downdraft mounting brackets
mounting screws