Extreme Networks VSP 4900 Series Installation Manual page 88

Power Cord Requirements for AC-Powered Switches
and AC Power Supplies
Power cords used with AC-powered switches or AC power supplies must meet the
following requirements:
•
The power cord must be agency-certified for the country of use.
•
The power cord must have an IEC320-C15 connector for connection to the switch or
power supply.
•
The power cord must have an appropriately rated and approved wall plug applicable
to the country of installation.
•
For cords up to 14.76 feet (4.5 m) long, the wire size must be 15 AWG (2 mm
minimum wire length up to 4.9 feet (1.5 m).
The power cords for switches that use either the 1100 W or 715 W power supplies are
keyed with a "notch" to ensure the proper orientation when plugged in. These cords
are of 3x14 AWG.
For details about obtaining AC power cords for use in your country, refer to
www.extremenetworks.com/product/powercords/.
88 VSP 4900 Series Switches: Hardware Installation Guide
Technical Specifications
2
)
http://