Table of Contents
Advertisement
Installing Expansion Modules
3. Using two fingers, remove the cover plate from the VIM slot.
a. Squeeze the sides to release the plate, and pull down from the top to open. The
plate will remain attached at the bottom.
Figure 24: Removing a slot Cover Plate (VIM slot cover shown)
4. Remove the new VIM from its anti-static packaging.
5. Install the VIM in the switch:
a. Carefully slide the VIM module into the switch.
b. Insert and tighten the retaining screws you previously removed, using the screws
provided.
Figure 25: Tighten Screws on the Inserted VIM Module
1 = VIM module retaining screw locations
Install an SSD Module
This section describes how to install a Solid-state Drive (SSD) module in the rear slot of
a switch.
You need the following tools and materials to install an SSD module:
•
ESD-preventive wrist strap
•
#2 Phillips screwdriver
Warning
To prevent damage to the switch or VIM, the switch must be powered OFF
when removing or installing SSD modules.
To install an SSD module, follow these steps:
1. Attach the ESD wrist strap to your wrist and connect the metal end to an
appropriate ground point on the rack.
VSP 4900 Series Switches: Hardware Installation Guide
Install an SSD Module
57
Advertisement
Table of Contents
