Oki ES9466 MFP Quick Start Manual page 19

Saving power when not in use – power saving modes –
The following modes are available; Automatic Power Save mode, Sleep mode, and Deep Sleep mode.
The table below shows the procedures to switch modes manually and conditions under which it enters
into or recovers from each mode.
Power saving Procedure to switch
modes modes
When a specified
Automatic
period of time
Power Save
passed since the last
mode
use of the equipment.
When you press the
[POWER SAVE] button
Sleep mode or when a specified
period of time
passed.
When you press the
[POWER SAVE] button
or when a specified
Deep Sleep period of time
mode passed.
*1 The default value is 1 minute.
*2 The [POWER SAVE] button on the control panel.
*3 The default value is 1 minute .
*4 The Wireless LAN/Bluetooth Module.
*5 Any of IPX, AppleTalk and other protocols. When the IPsec function is enabled or the Ethernet speed is set to [AUTO
(-1000MB)] or [1000BASE FULL], the equipment enters Sleep mode. For details, see the following guide:
& TopAccess Guide (PDF) : "Chapter 8: [Administration] Tab Page" - "[Setup] Item List"
*6 Depending on the network environment, the time for switching to Deep Sleep mode may take more than 10 minutes even if
it is set to 10 minutes or less.
To change the time for entering each mode, see the following guide:
& MFP Management Guide (PDF) : "Chapter 2: SETTING ITEMS (ADMIN)" - "GENERAL"
For the European version
Contact your service representative to change the default settings.
When the set time for switching to Automatic Power Save mode is the same as Sleep mode or Deep
Sleep mode, the equipment enters into Sleep mode or Deep Sleep mode.
If an original is placed on the original glass during power saving mode, the size is not detected even when the
equipment recovers from this mode. After pressing the [START] button or the [POWER] button to recover from
the mode, place it on the glass again.
Conditions to enter
the mode
has
*1
—
When a particular
option is installed or
*2 *4
when a particular
has protocol is enabled.
*3 *5
When a particular
option is not
*2 *4
installed and also a
has particular protocol
*3 *6
disabled.
Status of equipment
A message is displayed
to indicate the power
saving status.
The touch panel
display turns off and
the [POWER SAVE]
button turns green.
The touch panel
display turns off and
the [POWER SAVE]
is button turns green.
*5
Turning ON/OFF
Conditions to recover
from the mode
When you press the
[POWER SAVE] button,
or when print data or
fax data are received.
Same as the Automatic
Power Save mode.
When you press the
[POWER SAVE] button,
when print or fax data
are received through a
wired LAN, or when
the time set for
Scheduled Print has
come.
19
1