Ordering Spare Parts - Kenwood TS-450S Instruction Manual

TRANSMIT
| Symptom
Probable cause Corrective action
Low output . Microphone plug is not plugged
in.
2. Low microphone gain.
3. Poor antenna connection.
= —
. Plug MIC in.
2. Increase the MIC gain control.
3. Connect antenna securely.
VOX does not operate.
1. GAIN control too low.
i 2. ANTI control too high.
| 1. See section 4-11-11, GAIN
i control.
| 2. See section 4-11-11, ANTI
control.
| VOX trips by speaker output.
ANTI control too low. See section 4-11-11, ANTI control.
| Linear amplifier does not key.
1. The relay for the linear amplifier
does not operate.
2. REMOTE connector is miswired,
or has a poor contact.
=
. 4-18. Operate the relay by
referring to the section on
operation of the linear amplifier
in this manual.
2. Correct wiring.
6-5. ORDERING SPARE PARTS
When ordering replacement or spare parts for your equipment, be sure to specify the following:
Model and serial number of your transceiver. Schematic number of the part. Printed circuit board number on
which the part is located, part number and name, if known, and quantity desired. Part numbers for most
replacement parts are contained in the service manual (available as an option from your dealer or parts
distributor).
78